Danlers WAPIR PIR Occupancy Switch

Wall mounted PIR occupancy switch. The WAPIR model replaces an existing wall switch – no neutral wire is needed. It fits into a plaster depth wall box. The WAPIR model also has a manual override off switch on the front of the plate. The WAPIR requires a permanent live supply and should only be used in applications where the lights would not be on for more than 12 hours per day. This is to allow its rechargeable battery enough time to recharge itself from the mains supply. The WAPIR is supplied with a load capacitor to augment small loads. The override off button (out position) enables the lights to be held off during video presentations, etc. A version without the manual override button is also available on request (order code WAPIRX). For wall mounting only. IMPORTANT NOTE: Because WAPIR requires a permanent live supply there are restrictions on its usage: WAPIR should only be used in applications where the lights would not be ON for more time than they are OFF. This is to allow its rechargeable battery enough time to recharge itself from the mains supply. Wiring WAPIR’s in parallel will increase the ON status of a load and therefore the battery may not have sufficient time to recharge. The load MUST be able to pass parasitic current. The battery may not charge with some low energy / high efficiency luminaire products that do not pass sufficient parasitic current. If power factor correction capacitors are inbuilt to the luminaire, it is not advised to add additional CAPLOADs to the switching circuit. Applications The WAPIR is suitable for small offices, meeting rooms, tutoring rooms, etc. Specification Detection Zone: 120° Time lag range: 10 seconds to 40 minutes in 9 steps Photocell range: 100 to 1000 lux, and inactive Maximum Load: Up to 6 amps (1500W) of resistive, transformer or fluorescent lighting loads, up to 2 amps (500W) of low energy lighting loads (LED lamps and compact fluorescent) or up to 1 amp (250W) of fans or most metal halide lamps Minimum Load: 40W resistive or approximately 100W inductive per WAPIR in the circuit. A load capacitor (CAPLOAD) is supplied to augment small loads. Dimensions: 86 x 86 x 22mm. Wall box depth 16mm